Self adhesive wallpaper luzenandco | Geometric Patterns and Letters Wallpaper

Features -Textured Wallpaper(Recommended, Most durable)

• High Washability, Anti-Moisture
• Textured surfaces non woven wallpaper
• UV Rays Resistant, HP Latex Certified
• High Quality European Wallpaper
• Easy to application with paste
• Maximum printed width in one panel = 100cm
• Due to their high stability, non woven wall murals can be hung without a problem even over small cracks or bumps in the wall.
• Applying with overlap method
• High durability
• The high volume of the material (250g/m2 ) makes it sound absorbing and the room osier.
• Thickness : 0.11mm

Features -Non woven Wallpaper

• High Washability, Anti-Moisture
• UV Rays Resistant, HP Latex Certified
• High Quality European Wallpaper
• Easy to application with paste
• Maximum printed width in one panel = 100cm
• Due to their high stability, non woven wall murals can be hung without a problem even over small cracks or bumps in the wall.
• Applying with side by side method
• 180g/m2 
• Thickness : 0.11mm

Installation Steps for Self adhesive wallpaper

1.  Clean the wall, the wall must be clean, neat, smooth
2.  Make sure that the surface is flat(if not, Scuff uneven surfaces with a sandpaper and apply hard-type putty where necessary for a flat surface)
3.  Measuring the length and the width of the wall
4.  Cut off the size with 1-2cm extra leeway on all sides for trimming
5.  Touch The Wallpaper to peel off the adhesive tape and stick it on completely dry flat surface, No additional glue is needed.
6. Align the product with the application surface then pull the release paper about 5-10cm and stick the film onto the surface.
7. Apply the rest of the film by peeling the release paper 30cm at a time working from the top to bottom.
8. Use a squeegee to apply pressure onto the film from middle out towards both edges in order to push out any air bubbles.
9. Large air bubbles can be removed by pricking the bubble with a pin and pushing the entrapped air towards the puncture
10. Overlap the film by 0.5-1.5cm when installing two panels side by side

Installation Steps for Non woven or Textured Wallpaper

1.  Clean the wall, the wall must be clean, neat, smooth
2.  Roll wallpaper glue onto the section of the wall where you be applying first panel
3.  Hang the wallpaper
4.  Cut off excess material on top and/or bottom of the wall with craft knife
5.  Match wallpaper panels side by side, no overlapping needed
6.  Make sure to push out any air bubbles, if there are any
7.  Use a clean damp sponge to wipe off any excess glue, if needed
8.  Continue and repeat  the steps until the wall is done

Note

There may be a +0.1% difference in product’s dimensions due to production. Image’s color may change due to your chosen material.

As this wallpaper is custom made, we do not accept the returns or exchanges unless it is defective.

Image colour tones may be different more than your pc or phone screen.1 inches(1”)=2.54 cm
if you have any question about dimensions you can contact with us.